![]() This example code is in the public domain. 18 Rating s & 14 Comment s GeekBuddy Analysis 132 Players Community: (no votes) 1 Min Playing Time Age: 10+ Community: (no votes) Weight: 1. Then I have change timing in between the leds so here is the code: /* Blink Turns on an LED on for 1 second, then off for 1 second. 7.1 Vallco Professional Drag Racing Game (1975) Quick-playing statistically-based simulation of 1970's drag racing action. That one is Pre Stage (Pin 2) and the second one is for the Stage (Pin 3). I just want to help you making the best Tree Light for your practices. And I do not want you to think that you are wrong on your instructurable. I have change the timing and adde another white led I have been drag racing almost all of my life (EVOs, Hondas, RX7's) and I think It looks more closer to the real "Tree Light". Here is the same code but with some modifications. Pin 13 has an LED connected on most Arduino boards:ĭigitalWrite(2, HIGH) // White Led on for 1 secondĭigitalWrite(2, LOW) // LED turns off for 1/2 secondĭigitalWrite(4, HIGH) // Yellow led on 1/2 secondĭigitalWrite(4, LOW) // LED turns off for 1/2 secondĭigitalWrite(6, HIGH) // Yellow Led on for 1/2 secondĭigitalWrite(6, LOW) // LED turns off for 1/2 secondĭigitalWrite(8, HIGH) // Yellow Led on for 1/2 secĭigitalWrite(8, LOW) // LED turns off for 1/2 secondĭigitalWrite(10, HIGH) // Green Led on for 2 secondsĭigitalWrite(10, LOW) // Green LED turns off for 3 seconds In this diva-fied version of the classic board game, players better werk as they step into the heels of the reality shows contestants to buy, sell. initialize the digital pin as an output. Turns on an LED on for 1 second, then off for 1 second. The Code I wrote is a modified version of the blink example: The ground pin is located above the #13 pin (GND) on the Arduino board. I connected the jumper wires to the #2,4,6,8,10 pins found on the Arduino board and the long leg of the Led are placed in line with the end of the red jumper wires on the breadboard. I chose to build it this way because this is what I had. I understand there are many ways one can do this. You can also use a 9v battery with resistors that are appropriate or use usb from laptop or desk top computer. The power source is Altoids charger that supply's 5v to the Arduino board ( ) The Breadboard= Radio Shack (not necessary, but I already made the prototyping stand. The Arduino = Arduino UNO purchased at Radio Shack the media catalog is growing daily as new games are released hourly. The website also has videos to watch like cartoons, gameplay videos, and game walkthroughs. The Y8 platform has a social network of 30 million players and growing. I'm not sure if I have the timing right, but it's getting close. Y8 Games is a game publisher and game developer. I need the tree to be the same as the race track so my reaction time might improve. I built a homemade 24' drag strip to practice. I'm new to Arduino so I was excited to try this out. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |